INCH‐POUND
MIL-DTL-55422B
11 August 2011
SUPERSEDING
MIL-DTL-55422A
15 December 2001
DETAIL SPECIFICATION
CLIP, ELECTRICAL, GRID AND ANODE,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification establishes the general requirements for grid and anode types of electrical clips for
electron tubes.
1.2 Classification.
1.2.1 Part or identifying Number (PIN). PINs to be used for clip acquired to this specification are created as
follows:
55422/
1
-01
M
Military
General
Specification
Dash
designator
specification
sheet number
number
(see 3.1)
number
(1 digit)
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
Comments, suggestions or questions on this document should be addressed to DLA Land and Maritime, ATTN:
VAT, Post Office Box 3990, Columbus, OH 43218-3990, or emailed to relay@dla.mil. Since contact
information can change, you may want to verify the currency of this address information using the ASSIST
Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5999
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business