MIL-STD-1276 Leads For Electronic Component PartsThis standard establishes the method of identifying, specifying, and limiting to a minimum the combinations of basic materials, the thickness and composition of the plating used therewith, and the sizes of wire and flat wire ribbon leads on electronic and electrical parts when they are to be soldered or welded during assembly in equipment.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17

MIL-STD-1276H

FOREWORD

1. This standard is approved for use by all Departments and Agencies of the Department of Defense.

2. Comments, suggestions, or questions on this document should be addressed to: DLA Land and Maritime, ATTN: VAT, PO Box 3990, Columbus, OH 43218-3990, or emailed to Relay@dla.mil . Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database

at https://assist.dla.mil/.